Drill pipe takes severe bending loads downhole, and this video shows an automatic oil drill pipe straightening machine restoring used and new drill pipe to service. The pipe is loaded onto a heavy gantry-style frame where moving supports position each section, and the high-tonnage ram corrects deviation while dedicated thread protectors and soft contact pads shield the premium connections from any contact damage.
Built in 1000-ton class configurations, these machines handle long drill pipe within the Ø5–600 mm working range, at lengths up to 12 m. A long-bed measuring system uses 5–8 probes to map full-length deflection, the CNC applies correction in controlled steps, and each joint finishes within oilfield-acceptable straightness in a 20–90 second cycle — typically 5–10 times faster than manual floor pressing.
Oilfield service companies, drill pipe inspectors and OCTG yards use the machine to recondition pipe between wells, extending service life and keeping tubulars within inspection standards for drilling, workover and casing operations in the oil and gas sector. The footage lingers on the thread-protection tooling and the slow, controlled ram approach, showing how connection ends are kept well clear of the work zone while the body of the joint is corrected, then follows one joint through to final inspection handover.
Review capacity and automation choices in the straightening machine buyer’s guide, browse Bar & Tube Straightening Machines suited to oilfield tubulars, or contact our oil & gas team to discuss drill pipe sizes and thread-protection requirements.
Gantry-style 1000-ton class frame for oilfield drill pipe
Thread protectors and soft pads safeguard premium connections
Long-bed system with 5–8 probes maps full-length deflection
Controlled cycles beat manual floor pressing by 5–10x
Supports OCTG reconditioning to oilfield inspection standards
PRE：Crankshaft Straightening Machine
NEXT：没有了！
SITE：
