1 2 3
SITE:Home>Straightening Machine Videos

Automatic Bar Straightening Machine

DATE:2023-01-31   VISITS:777


Automatic Bar Straightening Machine for Shaft Blanks and Precision Stock

Bars that become shafts cannot afford hidden curvature, and this video shows an automatic bar straightening machine preparing precision bar stock. Each bar is measured while supported between centers or on rests, the CNC maps runout along the length, and the press ram applies measured correction at the flagged points — with results displayed before the bar leaves the machine.

The equipment handles bar from Ø5–600 mm and 100 mm to 12 m, in automatic cycles of 20–90 seconds. Measurement density follows the part: 2–3 points for short shafts, 5+ for long bars and up to 5–8 probes on long beds. Precision work achieves 0.02–0.05 mm TIR, with the most demanding bars held to ≤0.02 mm.

Machining shops, motor and pump manufacturers, linear motion builders and transmission makers straighten piston rods, motor shafts, lead screws and spindle blanks on this machine, protecting tight machining allowances and reducing chucking problems. The screen capture in the video shows runout values falling with each pass, making it easy to see why operators trust the machine to release bars straight the first time rather than reworking them later.

See how runout targets are defined and measured in our TIR and straightness explainer, review the Bar & Tube Straightening Machine selection, or request sample testing on your bar stock.

PRE:没有了!

NEXT:Automatic round steel straightening machine

PRODUCTS

SHANGDA straightening machine SHANGDA straightening machine SHANGDA straightening machine SHANGDA straightening machine
CONTACT US
Tengzhou Shangda Automation Equipment Co., Ltd.

Mrs Hu:+86 18863217097
E-MAIL:yanboh66@gmail.com
ADDRESS:Tengzhou Economic Development Zone, Shandong Province, China
SHANGDA straightening machine
Copyright © 2026 Tengzhou Shangda Automation Equipment Co., Ltd. All Rights Reserved.